Brunswick Frameworx LCD Interface Guide d'installation Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 50
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Aftermarket LCD Upgrade Manual
12 P/N 400-283-301 Rev A
Carefully lower the monitor from the scaffold and place front down on a piece of cardboard.
Repeat this step for the other monitor.
3.1 Existing Hanger
Make certain at least two people are available to support the hanger. Open the quick links
on one side and carefully remove the hanger from the chain support. Repeat on the other
side and lower cautiously to the floor, out of the way.
4 Hanger Assembly and Monitor Hanging
If your scoring system uses S-video cabling, it is strongly
recommended you make this connection prior to installing the
hanger bracket to the rear of the monitor.
The correct tool to use for this hardware is an 8MM nut
driver. Use caution when tightening monitor hanger hardware! Over-
tightening can cause severe damage. Refer to the Hanger Assembly
instructions and the warning on the next page for more information.
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 49 50

Commentaires sur ces manuels

Pas de commentaire